Toyspeed

I think you are answering your own questions really haha.

The biggest thing is the rust factor in AE92's, If Leon's one wasnt garaged he would be racing a cheese grater by now, As long as there is no current rust and you keep it garaged etc then it will last for years.
I had an AE92 FXGT with a ...

I inquired about this through my broker and the saving between the 2 were negligible, Although I was insuring a race car and the premiums were already cheap as its limited mileage etc..
Might be different on a road vehicle

There could also be the option of the S-GT Impreza (Japanese spec WRX) which is more in line with the money you are wanting to spend

Yeah, An old fella owns it now, Just wiped the drivers side off with a barbed wire fence apparently.

https://www.youtube.com/watch?v=qViFmuH4PL0 - Incar Video of my old car (New owner driving at Rally Otago)

I just sold my ae92 Rally car, I used a giant sheet of polypropylene sheeting for the under body protection, You can but it from a sign writing place, 5mm think, lasted numerous rallies and was hardly worn. Had a 6mm Standard Alloy sump Guard which was attached by two tabs welded onto the subframe ...

Leon wrote:pulled King/Koni suspension out of race car (AE92)

Put in Cobra/random cheap brand into race car.

now 30mm higher at the front and 45mm higher at the back.

Next, wheel align, then gravel ...

Yay, Jelous!!

Went up to Queenstown last weekend for QCC gravel sprint, first gravel event and found that driving on gravel is far different from driving on Grass. Was a really good day and managed 6th in 4WD class and 11th overall, which wasn't bad as I was one of only a couple people on road tyres as apposed ...

Probably not.

We have a few at work as we usually find we don't need them.

As long as the signal pulls right to ground then there is no problem.
Just hook the blue wire fron the 4 pin plug directly to the speed signal wire,
and they work fine.

Is yours one that is also GPS capable or is it an ...

What is the speed sensor interface that you have?

We usually wire them straight to the signal without anything.

The monits are a bit fussy with their signal too,
have had some issues with them we we first started fitting them,
but sussed out the reason for it.

The one for the monit, Speed ...

OK, so I found the installation guide for the apexi rsm and it is really handy for what I need, Even shows you what pins and which way to look at them etc... So it looks like I was correct in plug 135 pin 26 but the gnd I need in plug 134 pin 8, According to the guide its the pins as you look at ...

So I am trying to hook my Monit Tripmeter into the rally car, I have the plug in speed sensor interface wiring thing but I need to connect the 2 wires to the speed sensor wiring, Now I have found the following ECU Pinouts page m And if you look at ECU pinouts and scroll down my car would be the 99 ...

As Title says, Can any one recommend a good automotive repair/service centre preferably near Avalon, but Lower hutt is doable?

Thanks in Advance

Loose/worn belt?

As title says what is the best tool for cutting out parts of a dash and door panels? Needing to cut them around roll cage and a few other spots, cheers in Advance

Could be keen for the track/autocross double, Although what is the price for 2 drivers/same car if possible?

Boosted_162 wrote:Replaced air filter

Snap!

Grrrrrrr! wrote:Took it for a drive in its nice new clean and shiny state and proved that clean cars pull the young birds...

I see what you did there........

Got the new rally project car running on its own steam and wheels, Took it for a sneaky boost up the road and it scared the bejesus out of me. Should be interesting on the loose stuff lol

Leon wrote:If silvertop then will be 101

This