What's this?
Moderator: The Mod Squad
3 posts
• Page 1 of 1
What's this?
by Hachiroku » Tue Jun 21, 2005 11:57 pm
See the wee knobby-looking brass fitting on the left side of the front of the motor? My 2t-geu is leaking oil from there. Is it a timing chain tensioner or something else? What's the go with removing it to replace the washer/gasket?
- Hachiroku
- Toyspeed Member
- Posts: 386
- Joined: Sat Aug 31, 2002 6:05 pm
- Location: Auckland
by RS13 » Wed Jun 22, 2005 12:07 am
Yup, its the timing chain tensioner.
You can just unscrew it to take it out, but its' in 2 pieces, make sure you undo the whole thing (Pretty sure its a 17mm, keeping the stopper nut in the right place to keep tension the same) then just whack a new washer/gasket in it, I just used the old washer and a bit of good ol' RTV.
Out of curiosity, what car is this in?
You can just unscrew it to take it out, but its' in 2 pieces, make sure you undo the whole thing (Pretty sure its a 17mm, keeping the stopper nut in the right place to keep tension the same) then just whack a new washer/gasket in it, I just used the old washer and a bit of good ol' RTV.
Out of curiosity, what car is this in?
Daily driver: Toyota RunX/Toyota Caldina
Ex: 2x AE101, 5x KP60, KP61, EP71, 3x KE70, KE72, AE70, AE82, 2x TE71, AE90, AE92, ST170, plus 11 Hondas, 12 Nissans, 6 Fords, 4 Mazdas, 3 Mitsis, an Isuzu and a Lada!
Ex: 2x AE101, 5x KP60, KP61, EP71, 3x KE70, KE72, AE70, AE82, 2x TE71, AE90, AE92, ST170, plus 11 Hondas, 12 Nissans, 6 Fords, 4 Mazdas, 3 Mitsis, an Isuzu and a Lada!
-
RS13 - Toyspeed Member
- Posts: 3580
- Joined: Tue Oct 07, 2003 9:07 pm
- Location: Christchurch
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests