fitting mags
Moderator: The Mod Squad
3 posts
• Page 1 of 1
fitting mags
by bigfut » Sun Aug 21, 2005 5:05 pm
Just a question, is there any way to make some altezza factory wheels fit on a hiace? They are the same stud pattern, but the centre hole in the wheel is too small to fit over the centre thing (noob) on the van. Can these be machined to be bigger or would this weaken the structure of the wheel? Cheers
http://toyspeed.blakjak.net/profiles/profile.php?id=1702
The Harder You Fall The Higher You Bounce!
The Harder You Fall The Higher You Bounce!
-
bigfut - Toyspeed Member
- Posts: 311
- Joined: Thu Jan 02, 2003 5:19 pm
- Location: Hamilton
by UTERUS » Sun Aug 21, 2005 9:53 pm
You may find you will need spacers since hiaces and hilux's use a different offset to the altezza wheels. I had tezza wheels on my ute and 20mm bolt on spacers when it came from japan.
It is a myth that emos are contagious, and you may be infected. However, it is still widely accepted to wash your hands after physical contact
-
UTERUS - Toyspeed Member
- Posts: 1259
- Joined: Wed Sep 17, 2003 10:21 pm
by bigfut » Mon Aug 22, 2005 7:18 pm
oh ok, where can I get them from?
http://toyspeed.blakjak.net/profiles/profile.php?id=1702
The Harder You Fall The Higher You Bounce!
The Harder You Fall The Higher You Bounce!
-
bigfut - Toyspeed Member
- Posts: 311
- Joined: Thu Jan 02, 2003 5:19 pm
- Location: Hamilton
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests