Starting to piss me off!!
I have tried all the Mitsi forums so It's probably a long shot but MAYBE someone can help.
Mint 1997 Legnum VR-4, initially we had a fault with the traction control, it wouldn't work.....couldn't turn it on and off so we ASKED for it to be replaced so it would essentially work. We were told that was done and for at least a week or two it worked and all was good (well as far as I can tell it worked, using the switch on the bottom right of the dash I can turn it OFF (TCL OFF lights up) or on (nothing to say it's on but as no "off" light up I assume it is on?).
So after a week of normal use we get a check engine light coming on and in turn this turns the TCL off.
Well with what was "supposedly" done we decided we should get Mitsi motors to sort it, dropped it this morning & collected at the end of the day. Results:
"Report on engine check light coming on, checked with board compuiter, found codes 71 and 77 logged, 71 "TCL" vacum circut, and 77 Solenoid operation, cleaned and secured all electronic plugs and pins as required, cleared fault code and reset computer as required, road tested, all ok"
$121.50
Drove 40 km's home....all great, went to the olds for diner, got in 3 and a half hours later to head home.....1 min after driving away the check engine light is on and the tlc off
Mitsi say they aren't provided with all the "diagnostic" software or equipment and if what they did doesn't sort it they may need to get it looked at by an auto electrician as they can't work out anymore than that.
Now what!!?? Anyone know a decent auto electrician that knows there stuff but won't charge an arm & a leg??
Cheers
KiwiMR2