TVIS is it only actuators/pressure or ecu controlled aswel?

[~SlideWays~]

Im looking at ways to help with the spool on my 4agte. Its running a tvis manifold but no butterflies.

Is the Tvis system stand alone, as in no ecu control? I just need to know as my gze ecu obviously wouldn't have the output if there is one.

[Stealer Of Souls]

TVIS has an ECU signal according to my haynes manual for the AE92.

[~SlideWays~]

TVIS has an ECU signal according to my haynes manual for the AE92.

Shit.

I wonder if its possible to run tvis with the ae92 afm ecu? Maybe get a sparky to figure it out. Probably not since the ecu wouldn't have the output.

[Distrb]

i still have that complete tvis setup here gav if you require it

[~SlideWays~]

i still have that complete tvis setup here gav if you require it

Sweet You da man man.

I wonder if its going to be possible to run it though.... Cause damn my car is laggy

[sergei]

just use RPM switch device from jaycar... (www.jaycar.co.nz browse the kits section)

[~SlideWays~]

just use RPM switch device from jaycar... (www.jaycar.co.nz browse the kits section)

Sounds good. I had look but can't see it under the car section, have you seen it recently?

[sergei]

Here it is:
http://www.jaycar.co.nz/productView.asp?ID=KC5378&CATID
And here wich can do similar:
http://www.jaycar.co.nz/productView.asp?ID=KC5265&CATID

[~SlideWays~]

Here it is:
http://www.jaycar.co.nz/productView.asp?ID=KC5378&CATID
And here wich can do similar:
http://www.jaycar.co.nz/productView.asp?ID=KC5265&CATID

You're a legend mate