What I would like to know is can I swap the 2 regulators that I have here. The one in the bottom Right is one I "Acquired" from PaP, or are the not the same. It was out of a Camry/Whyndam.
Cheers
Neil
Alternator Regulators
Moderator: The Mod Squad
3 posts
• Page 1 of 1
Alternator Regulators
by Corona » Fri Apr 14, 2006 2:23 pm
For some time I have not had a No Charge Warning light. Now I know that when I ground the wire from the alternator the light goes on. I also know that it is charging as I have not got a flat battery.
What I would like to know is can I swap the 2 regulators that I have here. The one in the bottom Right is one I "Acquired" from PaP, or are the not the same. It was out of a Camry/Whyndam.
Cheers
Neil
What I would like to know is can I swap the 2 regulators that I have here. The one in the bottom Right is one I "Acquired" from PaP, or are the not the same. It was out of a Camry/Whyndam.
Cheers
Neil
Just remember: The glass is neither half full nor half empty, it is merely the wrong size
-
Corona - Toyspeed Member
- Posts: 187
- Joined: Tue Mar 16, 2004 8:34 am
- Location: North Shore, Auckland
by Corona » Fri Apr 14, 2006 6:21 pm
All_Fours wrote:should be fine swapping them, they should be set for the same reg. voltage. Why do you plan to swap anyway? Is your's under/over charging?
The Charging seems to be Ok, its just the No charge warning light not working. Thats all.
I'll have a go at swapping them at some stage when I get my other problem sorted out.
Just remember: The glass is neither half full nor half empty, it is merely the wrong size
-
Corona - Toyspeed Member
- Posts: 187
- Joined: Tue Mar 16, 2004 8:34 am
- Location: North Shore, Auckland
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 22 guests