Piston/conrod disassemebly

[Mr Revhead]

not that im aware of

[no_8wire]

Hmm ok...just dont want ot snap the piston walls when I try to press out the pin!

[matt dunn]

Ok this is weird... I pushed the piston as far to one side as possible, yet I couldnot see and circlip...any suggestions?




Weird.

You are looking for the clip on the outside of the gudeon pin not in near the conrod?

[Bazda]

its pretty much common sense, u dont go heat the crap out of them u just heat it up a litle bit at a time on a very light flame and a small tip like you would use for brazing, and it still takes quite a bit until the gudgens come out. Also you cant just aim the flame anywhere you want to.

and yes 7afe ones are a press fit, you will need to take them to a engine rebuilder who has a jig to get them out.

[no_8wire]

ok cheers...