Toyspeed.org.nz Message Board

by **Mr Revhead** » Mon Sep 18, 2006 1:16 pm

ok had some springs tested
at installed length of 38mm and at 8.1 lift

seated, 8.1 lift, free length

silvertop 56lbs 79lbs 48.1mm

black top 63lbs 88lbs 49.2mm

TRD 51lbs 106lbs 42.3mm

by **AceSniper** » Mon Sep 18, 2006 2:32 pm

good info thx

TRD ones free at 38mm and 51lbs at 38mm install hight?

by **Mr Revhead** » Mon Sep 18, 2006 2:40 pm

of course not, no idea what your on about :oops:

by **AceSniper** » Mon Sep 18, 2006 4:29 pm

my mistake

by **Bazda** » Mon Sep 18, 2006 6:30 pm

those are faily high figures for blacktop one, all the ones i measured (ie 40 of them lol) at 8.1mm were like 60 lbs.

by **Mr Revhead** » Mon Sep 18, 2006 8:04 pm

all the springs i had tested were brand new

by **Bazda** » Mon Sep 18, 2006 8:07 pm

I dont see how the valve spring can loose that much, maybe his tester thing reads diff to ours..
u send a trd one to me i'll put it on my spring tester

by **Mr Revhead** » Mon Sep 18, 2006 8:09 pm

you pay for one and ill send you one

i may be keeping some in stock, so if i do ill send one

by **Pies** » Mon Sep 18, 2006 10:50 pm

*coff* done the 16v ones yet? *coff*

by **Logan** » Tue Sep 19, 2006 9:24 am

Whats the coil bind on trd ones? ie how much lift can they take?

by **Mr Revhead** » Tue Sep 19, 2006 10:21 am

no idea.

ill go borrow a clamp and some verniers later on.
but from the looks of them id take some nasty cams to bind them up

Toyspeed.org.nz Message Board

20v valve springs

20v valve springs

Who is online