positioning cam gears on a 3sge
Moderator: The Mod Squad
3 posts
• Page 1 of 1
positioning cam gears on a 3sge
by tractionfree » Tue Dec 05, 2006 4:42 pm
when the engine is at TDC, what 'oclock' should the white dots on the cam gears be at? from an 86 motor but i dont know if that makes a difference. cheers
- tractionfree
- Toyspeed Member
- Posts: 125
- Joined: Thu Feb 27, 2003 1:39 pm
- Location: auckland
by strx7 » Tue Dec 05, 2006 5:32 pm
on the later ones, both notches in the camwheels are at 12 when the crack is at TDC, most likely the same for the early engines
Online Car Forums - Where Hui seems to take preference over Do-ey
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
- strx7
- Toyspeed Member
- Posts: 3707
- Joined: Mon May 24, 2004 12:06 am
- Location: Tauranga
by tractionfree » Tue Dec 05, 2006 7:26 pm
ah yep thats what i thought too. man once i get rid of this im never owning another east west again. i had to take off the cam gears to get to the power steering reservoir pipes! insane!
- tractionfree
- Toyspeed Member
- Posts: 125
- Joined: Thu Feb 27, 2003 1:39 pm
- Location: auckland
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests