hey all i have a 4agte still in the build i just got my hybrid T3-HT18 back from being built. It still has the internal wastegate but i can't be bothered making up brackets etc for the actuator and i'll loose the bling factor of the shiney compressor housing.
now would a 30mm external wastegate be too small to control boost for this type of turbo or would it be better to go for a 38-46mm wastegate? i'll be using the electronic boost control on the lem v5
any help would be appreciated
cheers
dylan
what size external wastegate
Moderator: The Mod Squad
6 posts
• Page 1 of 1
what size external wastegate
by sk1dlet » Sun May 20, 2007 2:00 pm
Last edited by sk1dlet on Sun May 20, 2007 2:09 pm, edited 1 time in total.
82 4DR KP62 4AGTE MADNESS
98 RS200 ALTEZZA
98 RS200 ALTEZZA
-
sk1dlet - Toyspeed Member
- Posts: 259
- Joined: Fri Jan 07, 2005 9:26 pm
- Location: Te Aroha
by flygt4 » Sun May 20, 2007 2:04 pm
i have an audi quattro one that is pretty close to a 38mm you can have a fair exchange of $ 
a 38mm is definately safe and would do what you want, would suck if went for one smaller and had to change it later. although i dont know what you can get thats smaller than 38mm?
a 38mm is definately safe and would do what you want, would suck if went for one smaller and had to change it later. although i dont know what you can get thats smaller than 38mm?
-
flygt4 - Toyspeed Member
- Posts: 3820
- Joined: Sat Sep 20, 2003 6:57 pm
- Location: Wellington
by thaphatty » Wed May 23, 2007 12:51 am
lols @ harder to make up a actuator bracket than buy fit and tune an external wastegaste.
Adamal wrote:Harro, this your captain speaking. Wercome to fright free nine five to Werrington
-
thaphatty - Toyspeed Member
- Posts: 1172
- Joined: Thu May 22, 2003 7:55 pm
- Location: Hamilton
by themaleman » Wed May 23, 2007 4:39 pm
its not that hard 2 make up a braket for the acuator
the faster u go, the quicker u get there
manual 80 series cruiser
4agte ae92 Levin
a15 powered sj410
manual 80 series cruiser
4agte ae92 Levin
a15 powered sj410
-
themaleman - Toyspeed Member
- Posts: 971
- Joined: Sat Dec 11, 2004 10:16 am
- Location: west auckland
by sk1dlet » Wed May 23, 2007 7:19 pm
thaphatty wrote:lols @ harder to make up a actuator bracket than buy fit and tune an external wastegaste.
hahaha yea but it's a good late bday pressie from the mrs lol will add a bit more bling and will take away a bit of the clutter in front of the turbo
82 4DR KP62 4AGTE MADNESS
98 RS200 ALTEZZA
98 RS200 ALTEZZA
-
sk1dlet - Toyspeed Member
- Posts: 259
- Joined: Fri Jan 07, 2005 9:26 pm
- Location: Te Aroha
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests