need help modifing a AE92 4age GTi
Moderator: The Mod Squad
need help modifing a AE92 4age GTi
hi
i have a AE92 GTi with a 4age in it
i am looking to modifiy it but not sure where to start
looking for cheap nd easy ways
Can any one help??
i have a AE92 GTi with a 4age in it
i am looking to modifiy it but not sure where to start
looking for cheap nd easy ways
Can any one help??
AE92 4age GTi
Building 3sge ae92 race car
Building 3sge ae92 race car
Malcolm wrote:I didn't know they had maths on waiheke
- metal_sean_head
- Toyspeed Member
- Posts: 676
- Joined: Thu Jul 23, 2009 9:11 am
- Location: Wellington.
Kittah wrote:Mugen badges IMO.
Aluminium floor panels will help too, in case you get danger to manifold.
Yeah when i have my laptop next to me it always tells me "danger to the manifold", but i just tell it to shut up and close it and then hit my second NOS button. The aluminium floors help alot. Now they only fall off every second race.
Seriously though,
Without knowing what in particular you want i cant help you directly but here are a few suggestions from me(not in any particular order):
Prob best to give it a real decent service-all fluids, filters etc
Aftermarket shocks and springs
New pads and fluid
Whiteline rear sway bar
Decent tires
Full exhaust system
Intake
Leads and plugs
VTEC: All of the lag and none of the boost.
89 AE92 FXGT
Big Port Redtop
TVIS!
19.8@32kph
89 AE92 FXGT
Big Port Redtop
TVIS!
19.8@32kph
metal_sean_head wrote:Yeah when i have my laptop next to me it always tells me "danger to the manifold", but i just tell it to shut up and close it and then hit my second NOS button. The aluminium floors help alot. Now they only fall off every second race.
He could also take his block to Dom and the mad scientist, his piston rings might need replacing.
Seriously though, listen to this man's suggestions. Unless you're going with forced induction, that's about as much as you can cheaply do. And that's not even particularly cheap, to be honest.
- 1I1
- Toyspeed Sponsor
- Posts: 3063
- Joined: Mon Oct 01, 2007 5:55 pm
- Location: Palmerston North
- Contact:
Leon wrote:What is your budget?
What are your goals with the car?
What is your level of mechanical ability?
Mostly, what is your budget.
This
Official TGP and TRD supplier to Toyspeed
TRD Clicky >>Here
mark@manawatu.toyota.co.nz (Please mention Toyspeed
)
TRD Clicky >>Here
mark@manawatu.toyota.co.nz (Please mention Toyspeed
- rollaholic
- Toyspeed Member
- Posts: 5383
- Joined: Fri May 28, 2004 1:19 am
- Location: West is Best
88.4ageGT wrote:um yea nos is not really what i was thinking.
anyone know if/where you can get body kits for this car?
Ah, right, you want to slow it down then. Put bags of cement in the boot. Cheapish, and should do the job.
All piss taking aside, $1500 will get you either:
1) new lightweight wheels and tyres
or
2) springs, shocks, adjustable rear sway bar, and a good wheel alignment
It won't get you any more power worth measuring.
- metal_sean_head
- Toyspeed Member
- Posts: 676
- Joined: Thu Jul 23, 2009 9:11 am
- Location: Wellington.
88.4ageGT wrote:thanks for that
um what about on the engine side of things?
it already has a pod filter on it
Is that just a $10 poddy sitting in your bay sucking in hot air doing more harm than good. Or a properly shielded ducted k&n sorta thing?
I did the shocks and springs in my FXGT and i have a blast in it in the corners. Not really fast but corners are where its at these days anyway.
VTEC: All of the lag and none of the boost.
89 AE92 FXGT
Big Port Redtop
TVIS!
19.8@32kph
89 AE92 FXGT
Big Port Redtop
TVIS!
19.8@32kph
- metal_sean_head
- Toyspeed Member
- Posts: 676
- Joined: Thu Jul 23, 2009 9:11 am
- Location: Wellington.