NZ Fastest toyota's down the strip....

General discussions on all non technical car related topics

Moderator: The Mod Squad

Postby Mr Revhead » Thu Aug 12, 2010 12:45 pm

I'm sure Xtrac or Ricardo etc will have somthing suitable, hows your $$ tree? :P
Being the subject of E-whinges since 2004 8)

http://www.centralmotorsport.org.nz/home

Image
User avatar
Mr Revhead
SECURITY!
 
Posts: 24635
Joined: Tue Jan 20, 2004 4:06 pm
Location: Nelson

Postby Malcolm » Thu Aug 12, 2010 12:56 pm

one issue I can see with making an MR2 real quick is that with the relatively short wheelbase and high reward weight bias you may very well get too much weight transfer to the rear and struggle to keep the front down. Yes, wheelie bars help here but any load that's on the wheelie bars reduces the amount on the driven wheels which isn't much good if you're already struggling for grip due to not being able to fit massive tyres under the guards.

as far as gearboxes go, there probably aren't many transverse transaxle type boxes stronger than the E153 anyway, except perhaps something from a big stupid american FWD V8.

I think a good solution could be to run a longitudinal engine and transaxle (like the couple of Audi V8 mr2s use). I've actually seen this done on a 10s (IIRC) sw20 from somewhere Scandinavian, using an Audi 5cyl motor. This would help increase forward weight bias and free up some room to tamper with the rear suspension geometry for more tyre clearance.
User avatar
Malcolm
Toyspeed Member
 
Posts: 4631
Joined: Tue May 14, 2002 1:01 am
Location: Auckland

Postby Lith » Thu Aug 12, 2010 1:06 pm

Surely nothing with putting wheelie bars on a MR? ;) Might actually make a SW20 look a little less dainty too.
2007 Mazdaspeed Axela
User avatar
Lith
Toyspeed Member
 
Posts: 3137
Joined: Mon Dec 02, 2002 5:22 pm
Location: Kapiti

Postby .:O4AGTZ:. » Thu Aug 12, 2010 1:12 pm

FYI - MR2 can wheelie very much :lol:

I think most may have already seen this but ill post it up anyway.

http://www.youtube.com/watch?v=Lg4AZAgjsc4
.:O4AGTZ:.
Toyspeed Member
 
Posts: 754
Joined: Sun Jun 11, 2006 6:15 pm
Location: Wellington

Postby Malcolm » Thu Aug 12, 2010 1:40 pm

Lith wrote:Surely nothing with putting wheelie bars on a MR? ;) Might actually make a SW20 look a little less dainty too.


Like I said, wheelie bars hold the nose down but take load off the rear tyres. Ideally you want them doing as little as possible
User avatar
Malcolm
Toyspeed Member
 
Posts: 4631
Joined: Tue May 14, 2002 1:01 am
Location: Auckland

Postby 1I1 » Thu Aug 12, 2010 1:48 pm

Just run a second engine/gearbox combo in the front :lol:
Official TGP and TRD supplier to Toyspeed
TRD Clicky >>Here
mark@manawatu.toyota.co.nz (Please mention Toyspeed ;))
User avatar
1I1
Toyspeed Sponsor
 
Posts: 3063
Joined: Mon Oct 01, 2007 6:55 pm
Location: Palmerston North

Postby .:O4AGTZ:. » Thu Aug 12, 2010 2:58 pm

1I1 wrote:Just run a second engine/gearbox combo in the front :lol:


I remember reading fast fours maybe 5 or so years ago and there was a street driven baby blue VW Golf that the guy had an engine in the front and another in the back. Both 2.8L turbos i think. Anyone else recall this? Think it was a guy in the UK
.:O4AGTZ:.
Toyspeed Member
 
Posts: 754
Joined: Sun Jun 11, 2006 6:15 pm
Location: Wellington

Postby Mr Revhead » Thu Aug 12, 2010 2:58 pm

Have seen it on youtube
Being the subject of E-whinges since 2004 8)

http://www.centralmotorsport.org.nz/home

Image
User avatar
Mr Revhead
SECURITY!
 
Posts: 24635
Joined: Tue Jan 20, 2004 4:06 pm
Location: Nelson

Postby 1I1 » Thu Aug 12, 2010 3:12 pm

Also there was an AE82 Corolla liftback in Europe that ran two 4AGTE's (350hp each) that was on High Octane Detonate
Official TGP and TRD supplier to Toyspeed
TRD Clicky >>Here
mark@manawatu.toyota.co.nz (Please mention Toyspeed ;))
User avatar
1I1
Toyspeed Sponsor
 
Posts: 3063
Joined: Mon Oct 01, 2007 6:55 pm
Location: Palmerston North

Postby Adamal » Thu Aug 12, 2010 3:54 pm

Motorsport is like sex. You could take it to track and have a long, enjoyable session, or you could take it to the strip and get it over with in less than 20 seconds.
User avatar
Adamal
Toyspeed Member
 
Posts: 11592
Joined: Sun May 02, 2004 4:01 pm
Location: Waitakere Drift Stage (Ranges)

Postby dusk93 » Thu Aug 12, 2010 5:01 pm

Current: 1983 AA60 Coupe, 1987 E30 318i coupe, 1985 SA70 Parts Heap, 1990 R32 GTST Coupe

Ex: 1982 AA60 Coupe, 1987 AE92 FXGT (RIP), 1989 Mazda Astina BG hatch, 1994 R33 Skyline GT ( RB20E powered :( )
dusk93
Toyspeed Member
 
Posts: 176
Joined: Sun Jun 07, 2009 12:26 pm
Location: Northshore, Auckland

Postby Al » Thu Aug 12, 2010 8:32 pm

http://www.youtube.com/watch?v=DDSR1Z_LuNQ

This car also uses a stupid amount of standard parts as well 8O
85 Corolla GT - 08 Blade Master G
Image
User avatar
Al
Toyspeed Member
 
Posts: 6146
Joined: Mon Jan 20, 2003 11:52 pm
Location: Christchurch

Postby Prymal » Thu Aug 12, 2010 10:14 pm

Akane wrote:
classique71 wrote:St205's run a stock 13.5 .. thats a good start ...


:lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol:


best motoring proved it with 5 back to back runs against numerous other japper cars , only beaten by the Supra .. Videos on youtube if you wanna hunt for it

My old one had no difficulty getting into the mid 13's - but it was designed for response , not top end or dragging ..

I know franks would have a good crack at a low 13, high 12 , and i know of at least 3 in australia with mid way mods that run high 12's ..

Its possible , just not as easy to do as in a common as F evo or WRX
St205 NZ New Group A WRC Gt4- Accept no Imitations !
Prymal
Toyspeed Member
 
Posts: 726
Joined: Thu Jul 13, 2006 11:17 pm
Location: Auckland

Postby Skin » Fri Aug 13, 2010 2:07 pm

classique71 wrote:
Akane wrote:
classique71 wrote:St205's run a stock 13.5 .. thats a good start ...


:lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol:


best motoring proved it with 5 back to back runs against numerous other japper cars , only beaten by the Supra .. Videos on youtube if you wanna hunt for it

My old one had no difficulty getting into the mid 13's - but it was designed for response , not top end or dragging ..

I know franks would have a good crack at a low 13, high 12 , and i know of at least 3 in australia with mid way mods that run high 12's ..

Its possible , just not as easy to do as in a common as F evo or WRX


My first 205 did a 13.2 with only a 3" cat back and 16psi...hardly massive power mods
cogent wrote:iPhones can eat a dick.


1981 Mazda RX7
1997 Toyota Corolla
User avatar
Skin
Toyspeed Member
 
Posts: 1438
Joined: Wed Oct 16, 2002 12:33 pm
Location: Perth, aussieland

Postby frost » Fri Aug 13, 2010 11:11 pm

i will be having a shot down the 1/4 when the 3s is in, hoping for a low 11.#
must beat my mates rb30 r32 gtst 11.4 on small turbo
frost
Toyspeed Member
 
Posts: 1705
Joined: Mon Aug 08, 2005 11:19 pm

Postby 99gtt » Thu Sep 02, 2010 10:46 pm

i done the 12.7 in my caldina at suprafest, could go faster kept popping intercooler hose clamps and havent been back to the drags since that day cant believe its been 2 years .
SOON TO BE 500 HP
User avatar
99gtt
Toyspeed Member
 
Posts: 336
Joined: Tue Aug 24, 2004 6:13 pm
Location: auckland

Postby audi man » Fri Sep 03, 2010 4:48 pm

Lith wrote:Umm, 28psi is no small amount still 8O I did 12s with a GT30 running 14psi in a car which is only RWD!

MR2s have epic potential, and of course there are things like the Croydens Supra etc which did 9s
Hey dont for get my little supra that as run about 20 9s passes and still running strong 8O
1.5 jz mk3 supra,675rwkws at 28psi and 723rwkws at 32psi
audi man
Toyspeed Member
 
Posts: 354
Joined: Sat May 31, 2003 12:54 am
Location: north shore

Postby strx7 » Fri Sep 03, 2010 7:29 pm

audi man wrote:
Lith wrote:Umm, 28psi is no small amount still 8O I did 12s with a GT30 running 14psi in a car which is only RWD!

MR2s have epic potential, and of course there are things like the Croydens Supra etc which did 9s
Hey dont for get my little supra that as run about 20 9s passes and still running strong 8O

not a 3sgte or 4wd though............
Online Car Forums - Where Hui seems to take preference over Do-ey

HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.

Motorsport Bay of Plenty - http://www.mbop.org.nz
strx7
Toyspeed Member
 
Posts: 3707
Joined: Mon May 24, 2004 12:06 am
Location: Tauranga

Postby gt4dude » Sat Sep 11, 2010 9:29 am

Argh that comment really irks me about the "it was too hard to get into the 12s so he bought an evo"

My car is fairly stock in terms of power, I'd cry if I got a time over the mid 13's.

Gotta find some more weight to ditch..
セリカGT-FOUR ST205 中期型 (Chuuki)
GT2860RS ・ JE 86.5φ PISTON ・ FX400 CLUTCH ・ APEX P-FC
200AWKW / 370NM
User avatar
gt4dude
Toyspeed Member
 
Posts: 723
Joined: Wed Apr 07, 2010 10:56 am
Location: Auckland

Postby dnalunchie » Sat Sep 11, 2010 10:18 am

gt4dude wrote:Argh that comment really irks me about the "it was too hard to get into the 12s so he bought an evo"

My car is fairly stock in terms of power, I'd cry if I got a time over the mid 13's.

Gotta find some more weight to ditch..


Unfortunately its true man, if you want to go fast in the 1/4mile bang for buck you can do much better than the ST205, I mean don't get me wrong, I love the GT4's but evo's seem to have some supernatural ability to post quick 1/4mile times.
EX:89 RS and GT Legacys, 90 EF9 Civic, 95 Integra R, 95 AE101, 90 ST185, 88 Accord, 87 3rdoor and 5door Swift hatch, 91 Pontiac Lemans, 80 Liftback Celica, 95 Hornet 250
Current: 90 3sfe Corona
User avatar
dnalunchie
Toyspeed Member
 
Posts: 3393
Joined: Wed Nov 10, 2004 12:07 am
Location: Christchurch

PreviousNext

Return to General Car Discussion

Who is online

Users browsing this forum: No registered users and 25 guests