3sge exhaust ports
Moderator: The Mod Squad
5 posts
• Page 1 of 1
3sge exhaust ports
by Townace » Thu Oct 07, 2010 9:26 pm
whats the spacing of the exhaust ports of a gen 2 engines vs altezza beams? could a gen 2 exhaust flange be welded to factory altezza extractors as a cheap gen 2 rwd exhaust option?
-
Townace - Toyspeed Member
- Posts: 108
- Joined: Wed Jun 23, 2010 7:25 pm
by Akane » Thu Oct 07, 2010 11:10 pm
nope, different bolt pattern 
No "stance", no "hellaflush", none of that bullshit. Nothing but no grip on full boost.
http://www.lol.co.nz/ random shit.
http://www.lol.co.nz/ random shit.
-
Akane - Toyspeed Member
- Posts: 4073
- Joined: Tue May 14, 2002 2:08 am
- Location: Auckland
by RomanV » Fri Oct 08, 2010 7:21 am
You sure you read the question Akane? 
Not sure about the exhaust side spacing, but I know that the intake port spacing is a bit different, I would assume the exhaust side is the same.
Not sure about the exhaust side spacing, but I know that the intake port spacing is a bit different, I would assume the exhaust side is the same.
-
RomanV - Toyspeed Member
- Posts: 4915
- Joined: Wed Aug 13, 2003 12:17 am
- Location: West Auckland
by Akane » Fri Oct 08, 2010 2:25 pm
RomanV wrote:You sure you read the question Akane?
No I don't
Nah they're slightly off IIRC. So it still stands as a no to a "good and cheap" mod.
No "stance", no "hellaflush", none of that bullshit. Nothing but no grip on full boost.
http://www.lol.co.nz/ random shit.
http://www.lol.co.nz/ random shit.
-
Akane - Toyspeed Member
- Posts: 4073
- Joined: Tue May 14, 2002 2:08 am
- Location: Auckland
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 8 guests