4agze Performance
Moderator: The Mod Squad
4agze Performance
Hi All,
I see a lot of people turboing 4agze setups, are the supercharged variants that dissapointing?
Reason I ask is that I am planning my next project, a small port AE92 which I am seriously considering throughing a ae101 supercharged front cut at (if i can find one) - I am well aware it is significantly cheaper/easier/better to just sell it and buy a Factory Supercharged one.
So the reason I am asking is so I can anticipate wether or not i will get to the end of the conversion and decide I want to turbo it, all out max power is not important, but if I can't give a vtec or mid range sky barge a run for its money (not piss on, but not get pissed on either) i would be disapointed...
thanks for taking the time to read.
I see a lot of people turboing 4agze setups, are the supercharged variants that dissapointing?
Reason I ask is that I am planning my next project, a small port AE92 which I am seriously considering throughing a ae101 supercharged front cut at (if i can find one) - I am well aware it is significantly cheaper/easier/better to just sell it and buy a Factory Supercharged one.
So the reason I am asking is so I can anticipate wether or not i will get to the end of the conversion and decide I want to turbo it, all out max power is not important, but if I can't give a vtec or mid range sky barge a run for its money (not piss on, but not get pissed on either) i would be disapointed...
thanks for taking the time to read.
AE92, KZJ120, KDJ120
- evil_si
- Toyspeed Member
- Posts: 2353
- Joined: Sat Nov 01, 2003 5:19 pm
- Location: TAURANGA, Pyes Pa
- Contact:
Ive had many of both s/c and turbo
I love the down low and take off performance of a s/c, and even better with one of my 175mm pulley kits,
But,
Same setup, same boost with turbo, little bit slower off the mark, but wow so much more fun right thru the rev range
I wish had of done a back to back dyno run, to compare s/c before, then turbo conversion after
I love the down low and take off performance of a s/c, and even better with one of my 175mm pulley kits,
But,
Same setup, same boost with turbo, little bit slower off the mark, but wow so much more fun right thru the rev range
I wish had of done a back to back dyno run, to compare s/c before, then turbo conversion after
- h8wrxs
- Toyspeed Member
- Posts: 1026
- Joined: Wed Apr 05, 2006 11:07 pm
- Location: travelling to candy mountain with my magical leoplurodon
someone i know did back to back runs with turbo vs s/c on a dyno
it was a stock setup on the first run, then pulled the s/c off, bolted up the turbo and i/c etc
the turbo made something like 17kw gain and torque increase right the way through the run
form memory it was a vf10 turbo i think
i used to have an ae92 gtz with one of evil_si's 175mm pulleys and i have to say i love the sound of the s/c whine, sounds awesome
it was a stock setup on the first run, then pulled the s/c off, bolted up the turbo and i/c etc
the turbo made something like 17kw gain and torque increase right the way through the run
form memory it was a vf10 turbo i think
i used to have an ae92 gtz with one of evil_si's 175mm pulleys and i have to say i love the sound of the s/c whine, sounds awesome
The four seasons in Australia consist of "$$% it's hot", "Can you believe how $$% hot it is?", "I won't be in today because it is too $$% hot" and "Yes, the dinner plate size spiders come inside to escape from the heat."
- Dell'Orto
- ** Moderator **
- Posts: 17494
- Joined: Tue Jul 08, 2003 4:07 am
- Location: Straight out the ghetto, Lower Hutt
Power gain is going to be totally dependant on what turbo you use.
For your car Solitaire, why not just turbo the smallport?
For your car Solitaire, why not just turbo the smallport?
1988 KE70 Wagon - Slowly rusting
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
Quint wrote:Not just cock, large cock.
- ~SlideWays~
- Toyspeed Member
- Posts: 4974
- Joined: Sat Nov 23, 2002 2:02 am
- Location: Wellington