Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

Need an adaptor plate made

General discussions on all non technical car related topics

Moderator: The Mod Squad

Post a reply

Need an adaptor plate made

Postby Vertigo » Thu Apr 12, 2012 8:56 pm

My cam angle sensor inserts fine, but the bolt holes wont line up thanks to manifold runners.. so I need a plate made. Anyone work at a fab shop, or alternatively, can make me something for a box of beers? Just needs two 12mm holes for bolts, and one 35mm hole for the CAS shaft. Can provide cardboard template.
Last edited by Vertigo on Thu Apr 12, 2012 9:51 pm, edited 1 time in total.
TVIS just kicked in, yo!
AW11 200kw 4AGTE build Discuss
Image
Vertigo
Toyspeed Member
 
Posts: 1172
Joined: Mon Aug 29, 2005 12:03 pm
Location: Auckland
Top

Postby Stu- » Thu Apr 12, 2012 9:10 pm

North Shore Plate Cutters? Send them a file or template then just tap if needed?
1985 Toyota Starlet EP71 (4agte)
Project Thread
http://garage4ag.wordpress.com
Auto electrical and ecu installation
User avatar
Stu-
Toyspeed Member
 
Posts: 1767
Joined: Wed May 15, 2002 4:17 pm
Location: Hiding from you...
Top

Postby evil_si » Thu Apr 12, 2012 9:30 pm

35cm is a pretty big hole
User avatar
evil_si
Toyspeed Member
 
Posts: 2353
Joined: Sat Nov 01, 2003 6:19 pm
Location: TAURANGA, Pyes Pa
Top

Postby Vertigo » Thu Apr 12, 2012 9:52 pm

lmao... 35mm i mean... cheers stu, will check em out.
TVIS just kicked in, yo!
AW11 200kw 4AGTE build Discuss
Image
Vertigo
Toyspeed Member
 
Posts: 1172
Joined: Mon Aug 29, 2005 12:03 pm
Location: Auckland
Top
Post a reply

Return to General Car Discussion

Who is online

Users browsing this forum: No registered users and 31 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.036s | 12 Queries | GZIP : On