1jz flywheel, where to get one

[Coldspark]

whats my best bet?

1. go buy a cnc one off trademe

2. sec hand one

3. or get a new one though Toyota


chairs

[Mr Ree]

What does each option cost?

[evil_si]

Cnc, talk to Brendon at convert

http://www.trademe.co.nz/Members/Listin ... er=3467571

[Coldspark]

ill get some costs on Monday


is anyone on here using a cnc one? whats the quality like of them?

[MrOizo]

Does it also matter what the clutch options are?

[Stott69]

How are you planning on balancing a cnc'ed one?

[atmosports]

If the guy who made it, knew what he was doing a CNC machined flywheel would be pretty close to be being balanced anway. But if not or your anal, take it to you local engine/driveshaft/turbo etc balance(Depending on size of there machine etc) & get them to zero balance it. Else if it's like some of those Ford motors with either a piece removed or added to the flywheel to get the balance correct I've done that with a cnc mill before as well,probably a lot more accurately than the factory cast/forged etc flwyheels.

I make grinding hubs, that spin to 25,000+rpm slightly about 400-500mm dia by up to 200mm long, all turn & mill in CNC machinery then sent to Lynn Rogers for a final balance, balance is always very close as usually there might be one or two holes smaller than 3mm drilled to get the balance correct & these are balanced way more critically then you'd do a flywheel

[strx7]

2nd hand on in my garage $200 inc courier and its yours.

[Coldspark]

cost are

1. go buy a cnc one off trademe $459.00

2. sec hand one $200

3. or get a new one though Toyota $350



I would kinda like to get a lite weight one tho but whats is the stock flywheel weight?