Toyspeed.org.nz Message Board

by **Ae92typeX** » Tue Jun 01, 2004 3:47 pm

Anyone know where abouts on the shore (pref) I can go to get my driveshaft lenghtened?
Im in the process of manual'n my supra but since I cant find a manual shaft will get mine lenghtened as the auto ones are shorter.
Cheers.

Toyspeed Profile - MrOizo · by **MrOizo** » Tue Jun 01, 2004 4:17 pm

Not on the shore but Beattys in Manacow are the best that i have dealt with so far...

you going to be going single piece or 2 piece?

by **Malcolm** » Tue Jun 01, 2004 4:36 pm

I have a driveshaft sitting in the back of my GA61 that may be of use, you can have it for $40 if it will fit

by **Ae92typeX** » Tue Jun 01, 2004 7:28 pm

All_Fours wrote:I have a driveshaft sitting in the back of my GA61 that may be of use, you can have it for $40 if it will fit

Any chance you could measure its length?- Im pretty sure the fittings will be ok. If its the correct length then I'll def buy it.

otherwise cheers MrOizo, if thats not the right size I will look at takeing mine to those guys. Mine's a 2 piece.

Website · by **gtRFungi** » Tue Jun 01, 2004 7:53 pm

thats not true. the left piece was attatched to the rocket cylynder

by **suckymotor** » Tue Jun 01, 2004 8:09 pm

automotive drive line in sunnybrae rd glenfield

by **Malcolm** » Thu Jun 03, 2004 8:46 pm

Just looking at the shaft, it looks a lot different to the one that's on the car, but I will go measure it....

it's just the front section, and from the tip of the shaft that goes into the gearbox to the 4 bolt flange at the back, it's 61cm

It is possibly the original one from the car, before it was converted to a 5MGE.

by **Ae92typeX** » Thu Jun 03, 2004 8:53 pm

Cool, cheers for that. Its definatly a different size to what I have. I will work out if its correct tomorrow- shaft next to my room, but boxes outside!
sounds hopefull, so please dont sell!

by **Ae92typeX** » Fri Jun 04, 2004 1:56 pm

is that 61cm pretty spot on?. Mine from the same points is 57cm and from what I work out it needs to be 64.5
argh, so close!

by **Ae92typeX** » Fri Jun 04, 2004 1:58 pm

in saying that, the input shaft does go in about 6cm from the seal.
anyone got an opinion on howmuch leeway could be used?

by **Malcolm** » Sat Jun 05, 2004 3:45 pm

Just come and take it. If it works then lucky you, if it doesn't then sell it for scrap to make back your petrol money.
PM me for my phone number

by **Ae92typeX** » Sat Jun 05, 2004 4:12 pm

pm'd

by **Bazda** » Sat Jun 05, 2004 9:20 pm

I know Precision engineering shorten drive shafts, so maybe they can lengthen them as well
located in albany

Toyspeed.org.nz Message Board

where to get driveshaft lengthened

where to get driveshaft lengthened

Who is online