Toyspeed.org.nz Message Board

by **RomanV** » Fri Nov 04, 2005 2:36 pm

My speedo stopped working yesterday, (1990 NA SW20) I would imagine due to a snapped speedo cable.

Has anyone replaced this before?
Or alternatively, are there any other possible causes?

I would imagine it would be a PITA job to do, if it is the cable.

OMG so shiny! · by **Dell'Orto** » Fri Nov 04, 2005 3:07 pm

Check the pin that comes off the speedo driven gear inside the gearbox, mine rounded off so didnt drive anymore

Cost like $18 for Toyota for a replacement.
I also have a new driven gear here if thats your problem

by **RomanV** » Fri Nov 04, 2005 3:19 pm

Hehe, thanks, will do.

Will PM you if that is the case.

by **minijrocks** » Fri Nov 04, 2005 5:26 pm

i think my wire is fraying. it sometimes reads and sometimes doens't. Does anyone have an engine diagram or links to, of when there wire goes from, i dont know what to look for in the engine bay, behind the cluster looks all good.

OMG so shiny! · by **Dell'Orto** » Fri Nov 04, 2005 5:37 pm

In what kind of car? Cause thats exactly what mine did before it rounded off properly.

by **minijrocks** » Fri Nov 04, 2005 6:32 pm

sorry, its a trueno 1991 4age

Just need to know where the wire comes thru firewall and into gearbox, i cant seem to find the wire

by **Alex B** » Fri Nov 04, 2005 8:27 pm

tis a cable on the back of the gearbox, prety hard to miss, its not a wire as such well not in the electrical sence.

Toyspeed.org.nz Message Board

MR2 speedo cable = snapped?

MR2 speedo cable = snapped?

Who is online