Manifold change for ST185 GT4

[4age_rage]

Was just curious as to whether a 3SGE inlet manifold can be used on a 3SGTE because as far as i know the throttle body sits on the end of the manifold as opposed to the middle which would suit my frontmount setup much better. Any help would be great

[Adydas]

Yes, as ive done the opposite by putting a 3sgte manifold onto a 3sge, just movest he inlet, but did in my case create issues with fitment of the TPS

in your case i dont know if that could cause issues under high boost say for number 1 getting less air for the mixture being the most far away inlet, Unlike the turbo setup where it goes in centrally? just a thought.

[4age_rage]

I think it may just be a case of experimenting, dont plan on running too higher boost, around 1 bar, time to look for a GE manifold i suppose , wouldn't happen to have one would you?

[Adydas]

i may actually, but its in my lockup or atm lockout as i aint paid it.

[4age_rage]

Sweet as man just flick me a pm if you find it or whatever

[HELBND]

seeing as you wont reply to PMs, where are my cupholders?

[strx7]

I have a caldina GT-T inlet manifold I'd sell

[Adydas]

hes after a NA style inlet manifold, not a top mount based unit as the calindas and gt4s etc use.

[strx7]

caldina inlet manifold has the throttle body ideally placed if running front mount IC piping.......

[Adydas]

u sure, i could swear it was the same..

[fivebob]

u sure, i could swear it was the same..

You shouldn't swear, it'll get you in trouble



but it won't fit a Gen II 3S-GTE anyway