Toyspeed

swap it for a sheet of ply...lol, Ive seen it done!

Handy site, especially for places you cant access easily.
Not all listings I tried, and a few gaps, but beats taking everything off first still.
FAQ it.

as above, or I'd question the 'origional wires' as it sounds like you have it earthed through the light feed.

as above, have you bridged the neutral start switch/inhibitor. need to do that when going auto-manual but otherwise should be fine.

Ive used tins of paint on hammerite many times. Averaged 3ish years before it started to look like it needed re-doing.
Prep is pretty important though to make sure it keys in fine in the first place.

Drill holes around the centre crush tube until you can remove it, then carefully with a hacksaw cut into the metal housing a couple of times, it comes out.
Hugely easier with a press, but if you've not got access to one, that method works well. Not as messy as burning the bush out either.

done ...

good you got the answer, but maybe be more specific in your searches to get valid results e.g. it would only be in general or tech - not off topic etc, generally.

Forums fine on my work and 2 home computers...all running different browsers too.

Hundie for a front set?
I'd probably sell for around that. If I was looking to buy I would say ~60 though. Depending on use the calipers are where the money is. 2nd hand discs not worth much.

could buy the real pannel sealer from toyota etc, use silicone, or my personal fave - dont bother.

Zak wrote:You don't have to replace the fly wheel, but you can't machine it, so if it's in poor condition then you have no choice.
...

what cant the tezza beams flywheels be machined?

these colours match?:

red: 12v ignition
yellow: 12v constant
Black: Earth
Green: Rear Laft + (stripe -)
violet: Rear Right
White: Front Left
Grey: Front Right

Blue/white stripe: External amp control
Blue: Antenna relay signal/control.

got a multimeter?, test whatever you unplugged from and you should be able to see which tw to bridge. (assuming no-one says the exact wires)

as above, pretty easy job that can be done one lazy morning, but if you dont have much of a mechanical apitude def get a mate or just leave with the mechanic to do

I always losened (just loosened) the tophat nut before removing the strut .
From memory on mine had to disconnect brake lines as ...

have to be careful with stats like that though. Really it indicates the 25% increase in it being reported. Thats not to say in reality it has gone up or down,just the stats of what is 'considered' to be violence or sex crimes has grown. Graphs, polls and numbers can be made to say anything when ...

so to clarify, each gauge has 6 wires yes?

what evil_si says above also though

Im still getting that message when I follow that link also

'no no no cant hotlink an image that way'

I never liked Johnny anyway.

in my last c series ox I ran Valvoline 75w90. No complaints.